SSANGYONG Rexton Y200 Manual page 546

1F2-18 M161 ENGINE CONTROLS
Camshaft Position Sensor Output Wave Inspection
1. Measure the output wave between the ECM
terminals No. 104 and No. 106 using the scan tool
or the oscilloscope while engine speed is at idle.
Notice: Replace the CAM sensor if cannot get the
output wave as shown in the figure.
Camshaft Position Sensor Power Supply Inspection
1. Disconnect the CMP sensor Connector.
2. Measure the resistance between the No. 1 and No.
3 pin of the CMP sensor connector while the ignition
switch is in "ON" position.
Specified Value
Notice: If the measured value is not within the
specified value, check the cable.
11 ~ 14 v
YAD1F160
SSANGYONG Y200