Table of Contents
Advertisement
4E-34 ABS AND TCS
Power Supply to Control Module, No DTCs Stored (Cont'd)
Step
1. Turn the ignition switch to OFF.
2. Trace the RW wires between terminal 15 of the
16
EBCM connector to fuse F7 of the I/P fuse block.
3. Repair the open in this circuit.
Is the repair complete?
Check the voltage between ground and terminal 20 of
the EBCM connector.
17
Is the voltage equal to the specified value?
1. Turn the ignition switch to OFF.
2. Check the resistance between ground and
18
terminals 16 of the EBCM connector.
Is the resistance equal to the specified value?
1. Turn the ignition to OFF
2. Check the resistance between ground and
19
terminals 16 of the EBCM connector.
Is the resistance equal to the specified value?
Examine terminals 15, 20, 16 of the EBCM connector.
20
Is there a defective terminal?
Repair the defective terminal or replace the connector
21
or wiring harness, as required.
Is the repair complete?
Replace the ABS unit.
22
Is the repair complete?
Repair the defective ground connection.
23
Is the repair complete?
Action
Value
Yes
-
System OK
11 - 14 V
Go to Step 19
-
System OK
≈ 0 Ω
Go to Step 20
-
Go to Step 21
-
System OK
-
System OK
-
System OK
No
-
Go to Step 18
-
Go to Step 23
Go to Step 22
-
-
-
SSANGYONG Y200
Advertisement
Chapters
Table of Contents
