Engine Coolant Temperature Sensor - SSANGYONG Rexton Y200 Manual

1F1-88 M162 ENGINE CONTROLS
Notice: Before removal, the fuel rail assembly may be
cleaned with as pray type cleaner, following package
instructions. Do not immerse the fuel rails in liquid
cleaning solvent. Use care in removing the fuel rail
assembly to prevent damage to the electrical
connectors and injector spray tips. Prevent dirt and
other contaminants from entering open lines and
passages. Fittings should be capped and holes
plugged during service.
Important: If an injector becomes separated from the
rail and remains in the cylinder head, replace the injector
O-ring seals and the retaining clip.
KAA1F090
12. Remove the injectors and the fuel rail carefully.
13. Remove the fuel injector retainer clips.
14. Remove the fuel injectors by pulling them down
and out.
15. Discard the fuel injector O-rings.
16. Lubricate the new fuel injector O-rings with engine
oil. Install the new O-rings on the fuel injectors.
17. Perform a leak check of the fuel rail and fuel
injectors.
18. Installation should follow the removal procedure
in the reverse order.
ENGINE COOLANT
TEMPERATURE SENSOR
Removal and Installation Procedure
1. Relieve the coolant system pressure.
2. Disconnect the negative battery cable.
3. Disconnect the engine coolant temperature sensor
connector.
Notice: Take care when handling the engine
coolant temperature sensor. Damage to the sensor
will affect the proper operation of the fuel injection
system.
YAA1F150
4. Remove the engine coolant temperature sensor
from the pump hosing.
Installation Notice
Tightening Torque
5. Installation should follow the removal procedure
in the reverse order.
30 N•m (22 lb-ft)
SSANGYONG Y200