SSANGYONG Rexton Y200 Manual page 630

1F3-6 DIESEL ENGINE CONTROLS
Actuator mechanism
Input of the desired valve is through control lever (6)
linkage lever (5) and reverse-transfer lever (11) to
variable fulcrum lever (13), and from there through strap
(2) to injection-pump control rack (4). The strap is
spring-loaded, and compensates for the extra
movement of the fulcrum lever. Similar to the guide
lever, the reverse-transfer lever is also flexibly mounted
at pivot point B of the sliding sleeve, and is also
attached to the fulcrum lever (13) via a shaft and
bushing. Full-load delivery at the fulcrum lever's lower
bearing point, which also acts as the spring-loaded
yield point for the fulcrum lever for absorbing the
sliding sleeve's additional travel in case of excessive
speed. The bearing shaft of the stop lever (3) protrudes
from the governor housing. Attached to its end is a
stop (shutoff) lever (1) which switches off the engine,
whereby the stop lever pulls the control rack in the
stop (shoutoff) direction.
4 Control Rack
6 Control Lever (Outer)
7 Full-Load Stop
9 Guide Lever
Cold-start setting (only the components concerned in the governing process shown.)
Starting the engine
The engine is to be started according to the vehicle
manufacturer's operating instructions. Normally, it can
be started without pressing the accelerator pedal. Only
with a cold engine at low temperatures is the accelerator
pedal to be pushed to the floor so that control lever (6)
is shifted up against full-load stop(7) – a fixed stop on
the governor housing. Reverse- transfer lever (11)
swivels around pivot point B, and in doing so shifts
fulcrum lever (13) in the "Start" direction. The result is
that the control rack (4) is moved to the start setting
and the engine receives the required start quantity.
Rapid speed regulation from the governor start setting
is made possible by lifting the auxiliary idle spring
(14) away from fulcrum lever (9) by a switch-off device
(21) when the control lever is in the full-load position.
11 Reverse-Transfer Lever
13 Variable-Fuicrum Lever
14 Auxiliary-Idle Spring
21 Auxiliary-Idle Spring Switch-Off
YAD1FAE0
SSANGYONG Y200