Fuel Pressure Regulator - SSANGYONG Rexton Y200 Manual

1F1-86 M162 ENGINE CONTROLS
14. Turn the roll over valves counterclockwise at an
angle of 90 degrees.
15. Turn the lock ring counterclockwise.
16. Remove and discard the gasket.
17. Installation should follow the removal procedure
in the reverse order.
YAA1F180

FUEL PRESSURE REGULATOR

Removal and Installation Procedure
1. Disconnect the negative battery cable.
2. Remove the fuel pressure test connector.
Installation Notice
Tightening Torque
KAA1F430
Caution: The fuel system is under pressure. To avoid
fuel spillage and the risk of personal injury or fire,
it is necessary to relieve the fuel system pressure
before disconnecting the fuel lines.
3. Relieve the fuel pressure in fuel supply system
by pressing the service valve.
KAA1F440
4. Disconnect the vacuum hose.
5. Disconnect the circlip and remove the fuel
pressure regulator.
6. Apply the oil to O-ring lightly and then replace it.
7. Perform a leak test of the fuel pressure regulator
with the engine off and the ignition on.
8. Installation should follow the removal procedure
in the reverse order.
KAA1F130
25 N•m (18 lb-ft)
SSANGYONG Y200