Front Wheel Speed Sensor - SSANGYONG Rexton Y200 Manual

SSANGYONG Y200

FRONT WHEEL SPEED SENSOR

Removal & Installation Procedure
1. Disconnect the negative battery cable.
2. Disconnect the front wheel speed sensor electrical
connector.
YAD4E340
3. Raise and suitably support the vehicle.
4. Turn the steering wheel to expose the front wheel
speed sensor. It is located at the rear of the
steering knuckle near tie rod end.
5. Remove the bolt and the front wheel speed sensor
from the steering knuckle.
Installation Notice
Tightening Torque
6. Installation should follow the removal procedure
in the reverse order.
YAD4E350
REAR WHEEL SPEED SENSOR
Removal & Installation Procedure
1. Disconnect the negative battery cable.
2. Disconnect the rear wheel speed sensor electrical
connector.
YAD4E360
3. Raise and suitably support the vehicle.
4. Remove the rear wheel speed sensor.
Installation Notice
Tightening Torque
5. Installation should follow the removal procedure
in the reverse order.
YAD4E370
ABS AND TCS 4E-93
7 N•m (62 lb-in)
7 N•m (62 lb-in)