Table of Contents
Advertisement
SSANGYONG Y200
M161 ENGINE CONTROLS 1F2-93
PEDAL POSITION SENSOR
Removal and Installation Procedure
1. Disconnect the negative battery cable.
2. Disconnect the pedal position sensor connector.
3. Unscrew the bolts and nut.
Installation Notice
Tightening Torque
4. Remove the pedal and sensor assembly.
5. Installation should follow the removal procedure
in the reverse order.
KAA1F410
OXYGEN SENSOR
Removal and Installation Procedure
1. Disconnect the negative battery cable.
Notice: The oxygen sensor uses a permanently
attached pigtail and connector. This pigtail should
not be removed from the oxygen sensor. Damage
or removal of the pigtail or the connector could
affect proper operation of the oxygen sensor. Do
not drop the oxygen sensor.
2. Disconnect the electrical connector.
3. Carefully remove the oxygen sensor from the
YAA1F820
exhaust pipe.
Installation Notice
Tightening Torque
Important: A special anti-seize compound is used
on the oxygen sensor threads. This compound
consists of aliquid graphiteand glass beads. The
graphite will burn away, but the glass beads will
remain, making the sensor easier to remove. New
or serviced sensors will already have the
compound applied to the threads. If a sensor is
removed from any engine and is to be reinstalled,
the threads must havean antiseize compound
applied before reinstallation.
4. Coat the threads of the oxygen sensor with an anti-
seize compound, if needed.
5. Installation should follow the removal procedure
in the reverse order.
6 N•m (53 lb-in)
55 N•m (41 lb-ft)
Advertisement
Chapters
Table of Contents
