SSANGYONG Rexton Y200 Manual page 1049

SSANGYONG Y200
AUTOMATIC TRANSMISSION 5A-181
5. Check the C4 piston bleed orifices are clear of
obstructions.
6. Lubricate the 'O' rings with ATF.
7. Fit the small 'O' rings onto the inner groove and
the large 'O' rings onto the outer groove of the
piston.
8. Position the clutch cylinder with the C2/C4 cavity
facing upwards.
9. Fit the C4 piston into the C2 piston with the bleed
orifices in alignment.
10. Install the C2/C4 piston assembly into the cylinder,
with the piston bleed orifices aligned with the holes
KAA5A0G0
on the outside of the cylinder, until the outer
diameter of the C2 piston enters the inner diameter
of the cylinder.
11. Assemble the piston return spring to the piston,
and fit the spring retainer over the spring.
12. Using 0555-336259 clutch spring compressor,
compress the spring sufficiently to enable the
installation of the retaining circlip ensuring that
the circlip is firmly seated in its groove, then
remove the tool.
Notice: The wire diameter of this spring is 4.3 mm.
13. Check the C1 piston check valves are not
damaged and are free to move, and that the
cylinder feed orifices are clear of obstructions.
14. Lubricate the 'O' rings with ATF and fit them to
KAA5A690
their respective grooves.
Notice: 'O' rings must not be twisted in the
grooves.