Hydraulic Modulator/Ebcm Assembly - SSANGYONG Rexton Y200 Manual

4E-92 ABS AND TCS
Bleeding System
Replacement modulators are shipped already filled
and bled. In normal procedures requiring removal of
the modulator, such as to replace the EBCM, air will
not enter the modulator, and normal bleeding will be
all that is needed.
If air enters the hydraulic modulator, or if an unfilled
modulator is installed, use the brake bleeding program
in the scan tool to bleed the modulator. Manual
bleeding of the hydraulic modulator is not possible.
HYDRAULIC MODULATOR/EBCM
ASSEMBLY
Removal & Installation Procedure
1. Disconnect the negative battery cable.
2. Disconnect the ABS wiring harness connector from
its socket on the EBCM.
3. Cover the connector and the socket with shop
cloths to protect them from brake fluid.
YAD4E310
Notice: Take care not to allow air into the hydraulic
modulator. If air gets into the hydraulic unit, it will
require a bleeding procedure using a scan tool
programmed for the ABS 5.3 system. As long as no
air enters the hydraulic unit, a simple bleeding
procedure is all the system will require.
4. Remove the brake pipes from the hydraulic
modulator.
Installation Notice
Tightening Torque
YAD4E320
5. Loosen the mounting nuts on the hydraulic unit.
6. Move the brake pipes aside far enough to allow
for lifting the ABS 5.3 unit out of the mounting
bracket.
7. Cap the brake pipes.
Installation Notice
Tightening Torque
•
Bleed the hydraulic system.
8. Installation should follow the removal procedure
in the reverse order.
YAD4E330
14 N•m (124 lb-in)
6 N•m (53 lb-in)
SSANGYONG Y200