Install The License File - Avaya CMC1 Installation, Upgrades And Additions

Task Table
You have 2 minutes to replace the Avaya MultiVantage Software card with
the translation card.
6. At the system prompt, log in as craft. Skipt to the next section.
7. Insert the original translation card into the TN2402 Processor circuit pack
slot and place the TN2402 into the slot vacated by the TN798 Processor
circuit pack.
8. Power up the cabinet.
9. Verify that the upgrade was completed to the expected software load.
If it is not the correct load, then the MultiVantage Software media must be
on-site and you must perform Steps 2-6 above.

Install the License File

Pre-installation
1. Type save translation and press
After the translations have been copied (about 10 minutes), the system
returns an error code, which must be a zero; otherwise, the translations are
not copied.
2. Type reset system 3 and press
Wait until the system has completely reset before continuing.
3. If the system has IP endpoints registered, unplug the Ethernet cable from
the TN799 (C-LAN) circuit pack.
This disconnects (unregisters) all IP endpoints.
4. Type set time and press
Ensure that the system date and time are set correctly.
Installation (direct connection)
If you have a direct connection between the RFA and the switch:
1. Go to the RFA website, and, following the instructions in the "Deliver to
G3r/G3si/G3csi" chapter of the RFA Job Aid, deliver the License File.
2. If the system has IP endpoints registered and you unplugged the Ethernet
cable from the TN799 (C-LAN) circuit pack, replug the cable.
This re-registers the IP endpoints.
555-233-118
Enter
NOTE:
This procedure sends the License File to the switch and installs it.
.
Enter
.
Enter
.
Issue 5 October 2002
3-17