Configuring IPSec VPN
Configuring a site-to-site IPSec VPN
This section describes the procedures for VPN configuration.
Installing the VPN license file
To enable IPSec VPN you must obtain and install a VPN license. For information on obtaining a
VPN license, see Installing and Upgrading the Avaya G450 Media Gateway, 03-602054.
You can install the VPN license via FTP, TFTP, or SCP.
Note:
You must have admin permissions to install a VPN license.
Note:
1. Use one of the following commands:
copy ftp license-file filename ip
●
copy tftp license-file filename ip
●
●
copy scp license-file filename ip
where:
●
●
For example:
copy tftp license-file my_license_file.xml 198.87.134.153
2. Optionally, enter show download license-file status to view the status of the
download process.
3. Enter show license status to verify that the license was installed.
4. Enter copy running-config startup-config to save your current configuration.
5. Reset using the reset command.
Configuring IPSec VPN
Prerequisites
As a prerequisite to configuring IPSec VPN, a valid VPN license must be installed on the G450.
For details, see
510 Administration for the Avaya G450 Media Gateway
filename is the filename, including the full path
ip is the IP address of the ftp/tftp/scp server
Installing the VPN license file
on page 510.