Common Mullion Type Properties; Circular Mullion Type Properties - Autodesk 24000-000000-9860 - Revit Architecture - PC User Manual

Name
Comments
Mark
Phasing
Phase Created
Phase Demolished

Common Mullion Type Properties

Name
Material
Constraints
Angle (not available for corner mul-
lions)
Offset
Construction
Profile (not available for corner mul-
lions)
Position (not available for corner mul-
lions)

Circular Mullion Type Properties

Name
Offset
Radius
724 | Chapter 11 Working with Architectural Components
Description
Specific comments about the curtain wall.
Sets a label for the curtain wall. This value must be unique for each curtain wall
in a project. Revit Architecture warns you if the number is already used but al-
lows you to continue using it. (You can see the warning using the Review
Warnings command. See
The phase when the curtain wall was created.
The phase when the curtain wall was demolished.
Description
Sets the mullion material type.
Rotates the mullion profile. Works as an adjustment to the Position parameter. Note
that this parameter is not enabled for circular mullions.
Sets the offset from the panels in the curtain element.
Sets a profile for the mullion. You can create a custom profile family. See
Families on page 371.
Rotates the mullion profile. Normal to Face is the usual condition. Parallel to Ground
is appropriate for sloped curtain panels, such as in a sloped glazing or a sloped
curtain system.
Description
Sets the offset from the panels in the curtain element.
Sets the radius for the circular mullions.
Reviewing Warning Messages on page 1334.)
Profile