Wall Foundation Instance Properties - Bearing - Autodesk 24000-000000-9860 - Revit Architecture - PC User Manual

Name
Volume
Elevation at Bottom
Identity Data
Comments
Mark
Phasing
Phase Created
Phase Demolished
Structural Analysis
Analyze As

Wall Foundation Instance Properties - Bearing

Name
Constraints
Eccentricity
Structural
Rebar Cover - Top Face
Rebar Cover - Bottom Face
Rebar Cover - Other faces.
858 | Chapter 12 Working with Structural Components
Description
Indicates the volume of the foundation. This is a read-only parameter.
Elevation at the bottom of the retaining wall. This is a read-only parameter.
A field for placing general comments about the foundation type.
A label created for the foundation. This value must be unique for each element
in a project. Revit Architecture warns you when the number value is already used
but allows you to continue using it. You can see the warning using the Review
Warnings command. See Reviewing Warning Messages
Indicates in which phase the foundation component was created. See
Phasing on page 1263.
Indicates in which phase the foundation component was demolished. See
Phasing on page 1263.
Indicates the property type for structural analysis. Select either Foundation or
Not for Analysis.
Description
Specifies the offset from the wall center line to the bearing foundation center
line.
Specifies the rebar cover distance from the wall foundation top face.
Specifies the rebar cover distance from the wall foundation bottom face.
Specifies the rebar cover distance from the wall foundation to an adjacent ele-
ment faces.
on page 1334.
Project
Project