Wall Foundation Instance Properties - Retaining - Autodesk 24000-000000-9860 - Revit Architecture - PC User Manual

Name
Identity Data
Model
Manufacturer
Type Comments
URL
Description
Assembly description
Assembly Code
Type Mark
Cost

Wall Foundation Instance Properties - Retaining

Name
Structural
Rebar Cover - Top Face
Rebar Cover - Bottom Face
Rebar Cover - Other faces.
Estimated Reinforcement Volume
Dimensions
Length
Width
Description
The manufacturer internal number.
The foundation manufacturer.
A field for entering general comments about the foundation type. This information
can be included in a schedule.
A link to a web page that may contain type-specific information.
Enter an optional description of the wall foundation.
Describes the assembly based on the assembly code selection. This is a read-only
parameter.
A uniformat assembly code selected from a hierarchical list.
A value to designate the particular foundation. This value must be unique for each
element in a project. Revit Architecture warns you when the number value is already
used but allows you to continue using it. You can see the warning using the Review
Warnings command. See Reviewing Warning Messages
The pricing of the foundation.
Description
Specifies the rebar cover distance from the wall top face.
Specifies the rebar cover distance from the wall bottom face.
Specifies the rebar cover distance from the wall to an adjacent element faces.
Specifies the estimated reinforcement volume of the selected element. This is a
read-only parameter that only displays when rebar has been placed.
Indicates the overall length. This is a read-only parameter.
Indicates the overall width. This is a read-only parameter.
on page 1334.
Wall Foundation Properties | 857