Suzuki Baleno Manual page 1176

9J-76 AIR BAG SYSTEM
PASSENGER AIR BAG (INFLATOR) MODULE
WARNING:
D Never attempt to disassemble or repair the passenger air bag (inflator) module. If any abnormality
is found, be sure to replace it with new one as an assembly.
D Be sure to read "SERVICE PRECAUTIONS" and "HANDLING PRECAUTIONS" before starting to
work and observe every precaution during work. Neglecting them may result in personal injury or
undeployment of the air bag when necessary.
1. Glove box
2. Instrument panel
1. Passenger air bag (inflator) module
2. Instrument panel
REMOVAL
1) Disconnect negative battery cable at battery.
2) Open glove box, then while pressing glove box stopper, pull out
glove box from instrument panel.
3) Disable air bag system. Refer to "DISABLING AIR BAG SYS-
TEM" in this section.
4) Remove passenger air bag (inflator) module attaching bolts and
screws, and passenger air bag (inflator) module from vehicle.
WARNING:
D When carrying a live air bag (inflator) module, make
sure the bag opening is pointed away from you.
Never carry air bag (inflator) module by wires or
connector on the side of the module. In case of an
accidental deployment, the bag will then deploy
with minimal chance of injury.
D As the live passenger air bag (inflator) module must
be kept with its bag (trim cover) facing up while be-
ing stored or left standing, place it on the work-
bench with a slit or use the workbench vise to hold
it securely at its lower mounting bracket. This is
necessary so that a free space is provided to allow
the air bag to expand in the unlikely event of acci-
dental deployment.
D Observe "HANDLING PRECAUTIONS" earlier in
this section for handling and storing it.
D Otherwise personal injury may result.
INSPECTION
WARNING:
Never measure resistance of passenger air bag (inflator)
module or disassemble it. Otherwise, personal injury
may result.
CAUTION:
If air bag (inflator) module was dropped from a height of
91.4 cm (3 ft) or more, it should be replaced.