Suzuki Baleno Manual page 1177

1. Passenger air bag (inflator) module
2. Instrument panel
Check air bag (inflator) module appearance visually for the follow-
ing symptoms and if any one of them is applicable, replace with a
new one.
D Air bag has deployed.
D There is a crack in trim cover (pad surface).
D Wire harness or connector is damaged.
D Air bag (inflator) module is damaged or a strong impact (e.g.,
dropping) was applied to it.
1. Trim cover
2. Case
3. Connector
INSTALLATION
1) Install passenger air bag (inflator) module to vehicle.
2) Tighten passenger air bag (inflator) module attaching bolts and
screws to specified torque.
Tightening Torque
(a): 23 N m (2.3 kg-m, 16.5 lb-ft)
(b): 5.5 N m (0.55 kg-m, 4.0 lb-ft)
3) Connect negative battery cable to battery.
4) Enable air bag system. Refer to "ENABLING AIR BAG SYS-
TEM" in this section.
DRIVER AIR BAG (INFLATOR) MODULE
Refer to Section 3C1 for removal, inspection and installation.
CONTACT COIL AND COMBINATION
SWITCH ASSEMBLY
Refer to Section 3C1 for removal, inspection and installation.
"AIR BAG" WARNING LAMP
Refer to Section 8 for removal and installation.
AIR BAG SYSTEM 9J-77