SSANGYONG Rexton Y200 Manual page 92

SSANGYONG Y200
M162 ENGINE MECHANICAL 1B1-51
Inspection
1. Measure the basic bore of the connecting rod
bearing.
Notice: If the basic bore exceeds the value of
51.614 mm, replace the bearing or check the
connecting rod.
YAD1B980
2. Check connecting rod bolts.
Length When New (L)
Max. Length (L)
Tightening Torque
Notice: If the length exceeds max. length, replace
it.
YAD1B990
3. Check the assembly mark(indication//or number:
arrow) of the connecting rods and the bearing cap
when installing.
Notice:
•
Make sure it doesn't exceed over 4g with other
connecting rods when replacing the connecting
rods.
•
Check if the connecting rod and the bearing
cap are accurately seated on the groove when
replacing the bearing.
YAD1B0A0
51.7 - 52 mm
52.9 mm
1st step: 40 + 5 N•m
(30 + 3.7 lb-ft)
2nd step: 90°+10°