SSANGYONG Rexton Y200 Manual page 77

1B1-36 M162 ENGINE MECHANICAL
Tools Required
601 589 03 43 00 Crankshaft Rear Seal Installer
Removal & Installation Procedure
1. Unscrew the bolts (1) and (5) and remove the
closing cover by pulling the rear cover lug (arrows).
Notice: Be careful not to damage the oil pan
gasket.
YAD1B740
2. Clean the sealing surface of the crankcase and
the rear sealing cover.
3. Check the radial shaft seal and replace it if
necessary.
4. Apply the Loctite 573 to the rear cover sealing
surface.
5. Apply the engine oil to the dust lip of the radial
shaft seal.
Notice: Do not use the grease.
YAD1B750
6. Install the crankshaft rear radial seal and the
crankshaft sealing rear cover, using crankshaft rear
seal installer 601 589 03 43 00.
YAD1B760
7. Install the crankshaft sealing rear cover mounting
bolts and remove the crankshaft rear seal installer
601 589 03 43 00.
Installation Notice
Tightening Torque
YAD1B770
9 - 11 N•m
(80 - 97 lb-in)
SSANGYONG Y200