SSANGYONG Rexton Y200 Manual page 89

1B1-48 M162 ENGINE MECHANICAL
Inspection
1. If the length 'L' of the crankshaft bearing cap bolt
exceeds 63.8 mm, replace it.
YAD1B930
2. Make sure the crankshaft bearing cap is properly
seated on the cylinder block (arrows).
YAD1B940
3. Measure and record the inner diameter of the
crankshaft bearing.
Notice:
•
Measure at 2 points (1, 2).
•
Measure 'A','B'and 'C' as shown. If average
value of 'B' and 'C'is less than value 'A', then
the average value of 'B' and 'C' is actual
average value. If average value of 'B' and 'C' is
more than value 'A', then the value 'A' is actual
average value.
YAD1B950
4. Measure and record the diameter of the crankshaft
bearing journal.
Notice:
•
Record the mean value when measured at 3
points (A, B, C).
•
Measure the inner diameter of bearing and the
diameter of journal and if it is out of the standard
data, replace the bearing shell.
YAD1B960
SSANGYONG Y200