NEC Univerge sv8500 Manual page 873

Analog Caller ID
CALLER ID information (Calling Number and Calling Name) can be displayed on called terminals (Dterm
and DtermIP stations with LCD) for the calls via CALLER ID-compliant analog C.O. line.
Follow the service conditions below:
(a) Firmware SP3875 6MGCOT PROG-A Issue 4.0.0.0 or later version is required.
(b) Up to 24 characters of Calling Name can be displayed on the called terminal. When the informed
Calling Name exceeds 24 characters, only the Calling Number is displayed. Any characters of Call-
ing Name are not considered.
(c) The display on the called terminal is shown like below.
e.g.) When the Calling Name display takes priority:
When the Calling Number display is assigned to take priority over Calling Name display, the displayed
Note:
lines for the Calling Number and the Calling Name are inverted. In this case, the first eight characters of
Calling Name (company name) can be displayed.
(d) Caller information display is available only for the incoming call from C.O. line terminated directly
to each station. Caller information cannot be displayed when intermediate station exists by Call For-
warding. When the intermediate station hangs up, the Caller information can be displayed.
12345678
term
D IP
ABCDEFGHIJ
Caller information is
displayed on the called
station.
Calling...
VOL.2-620
MG-COT Card [SCA-6COTB]
MG-COT
PSTN
Analog Telephone
Calling Number [8 digits]
Calling Name [24 characters]