NEC Univerge sv8500 Manual page 947

4. Setting DNS Server
MG-COT(SIP)> SET DNS_SW
DNS Interface (ENABLE/DISABLE) [ENABLE]: ENABLE
DNS IP Address [0.0.0.0]: 10.41.2.101
DNS setting succeeded.
The designated DNS Server cannot be applied when Proprietary Protocol mode. Assign the SP mode before
Note:
executing this DNS Server setting.
The value in [ ] shows the current setting. Press enter key to apply the current setting shown in [ ].
Note:
When DISABLE is selected, the setting line of DNS IP Address is not displayed.
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
5. Setting IP address and port number of DRS
MG-COT > SET DRSADDRESS
DRS Unit (1:Primary/2:Secondary/3:Tertiary/
4:Forth) : 1
DRS IP Address [0.0.0.0] : 150.10.1.100
DRS Port Number (1024-65535) [3456] : 3456
DRS setting succeeded.
The designated DRS setting cannot be applied when SP mode. Assign the Proprietary Protocol mode before
Note:
executing this DRS setting.
The value in [ ] shows the current setting. Press enter key to apply the current setting shown in [ ].
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
About IP address of DRS (Telephony Server), refer to "Registration Destination of IP Devices/Stations" in
Note 1:
INTRODUCTION of Installation Manual.
Line2: ENABLE=DNS server is used
Line3: Enter the IP address of DNS
Line 4: Result is shown.
Line 2: Select "1" for the Telephony
Line 3: Enter IP Address of DRS. (e.g.
Line 4: Enter Port Number of DRS
Line 5: Result is shown.
VOL.2-694
MG-COT Card [SCA-6COTB]
DISABLE=DNS server is not
used (default)
server (e.g. 10.41.2.101)
Server in normal condition.
150.10.1.100) Note 1
(1024-65535, default = 3456).