NEC Univerge sv8500 Manual page 1333

MG-PRI> set ipaddress 192.168.0.11 255.255.255.0
2
1
1: Command
2: Sub Command
3: Parameter 1
4: Parameter 2
The number of parameters to be specified is different depending on the command.
Note:
MG-PRI> SET DRSQOS
QOS (TOS/DIFFSERV:TOS):TOS
5: Set Value (or Default Value)
In SET command, some of the sub commands can be specified with hexadecimal numbers (called Set Value), which deter-
mine a group of the detailed values. It is also possible to omit its parameters; the interactive guidance will help you speci-
fying its detailed values. The following shows these patterns:
When the parameters are specified:
MG -PRI> SET PRI_T1_1 90B8
set value is 0x90B8
setting succeeded.
In order to make a setup reflect and keep, re-starting is required
after saving a configuration file by SAVE command.
When the parameters are Not specified:
MG -PRI> SET PRI_T1_1
Dch Control
Dch Mode
Dch Signal Logic
Dch-1 Drop/Insert
Dch-2 Drop/Insert
Drop/Insert Mode
Data Transfer Speed ( 0-2: 0 ): 0
Drop/Insert Time Slot ( 0-23: 23 ): 23
Dch Signaling Set
set value is 0x90B8
setting succeeded.
In order to make a setup reflect and keep, re-starting is required
after saving a configuration file by SAVE command.
3 4
5
( 0/1: 1 ): 1
( 0/1: 0 ): 0
( 0/1: 0 ): 0
( 0/1: 1 ): 1
( 0/1: 0 ): 0
( 0/1: 0 ): 0
(0/1: 0): 0
VOL.2-1080
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]
Set Value