NEC Univerge sv8500 Manual page 1053

12.1.4 Requirements
1. Hardware Requirements
• PC running Terminal Software (for Maintenance Console)
• Cables
LAN cable:
Line Cable:
EMA TEL Cable: For the connection between Emergency telephone and MG(BRI), use a Modular
CONSOLE Cable:
Audio Cable:
2. Firmware Program
• Installed Firmware: SP-3826 BRI MG SIP BSC PROG-A
3. Environmental Requirements
• Temperature: 0 °
• Humidity: 20%~90% (not condensing)
• Main Source Power: AC100V/120V/230/240V (50/60 Hz)
Use any of the following cables for connecting to LAN.
10BASE-T:Unshielded Twisted-pair (UTP) Straight-through Cable Category 3 or
higher, (a maximum of 100 m)
100BASE-TX:Unshielded Twisted-pair (UTP) Straight-through Cable Category 5
or higher, (a maximum of 100 m)
For the connection to ISDN network (T point), use a
DSU with an RJ-45 Modular Jack.
Cable with an RJ-45 Modular Jack.
RJ-45 ⇔ RS-232C serial cable (for maintenance console)
Microphone input (for external hold-tone source)
3.5 φ mini-jack (monaural type)
C~40 ° C (32 ° F~104 ° F)
VOL.2-800
MG(BRI) [SCA-2BRIA/MG-2BRIA]
Twisted-pair Cable for
0.5φ
±
10%