NEC Univerge sv8500 Manual page 1244

13.4.4 SHOW Command
1. SHOW Δ BCH_ATTRIBUTE
This command is used to display the setting of Bch parameters.
:
COMMAND 1
MG-PRI > SHOW BCH_ATTRIBUTE 00
FAX PROTOCOL ECM
CH00 BYPASS OFF
COMMAND 2
MG-PRI > SHOW BCH_ATTRIBUTE ALL
FAX PROTOCOL ECM
CH00 BYPASS OFF
CH01 BYPASS OFF
:
:
CH29 OFF ON
2. SHOW Δ DHCP
This command is used to display whether DHCP is enabled at current network.
MG-PRI> SHOW DHCP
DHCP is ENABLE
Δ P1
FAX RATE
14400
FAX RATE
14400
4800
9600
VOL.2-991
P1-Specify Bch parameter to be displayed
0-29=Circuit Number
ALL=All the channels are displayed
A command is executed, and the result is displayed.
-When specifying circuit card number, COMMAND1 is
displayed
-When specifying ALL, COMMAND2 is displayed.
The current setting is displayed.
MG-PRI/PRA