Conditions Specific To Umg System; Interaction With Other Features - NEC Univerge sv8500 Manual

24. When Trunk Soft Hold Timer is effective, the call originating party will be charged when the timer
expires.
25. A Conference cannot be established until the False Answer Timer expires.
26. SMDR cannot be collected until the False Answer Timer expires.
27. Adding a pause when originating to Central Office Line is available since FP85-105 S2. The conditions
are below:
• The required firmware is the following: SP-3778 MCMG PROG-A Issue 16 or later/SP-3927 MCMG
PROG-B Issue 5 or later.
• The features which can be added a pause are the followings:
(1) Speed Calling - System [S-3] / Speed Calling Override - System [S-61]
(2) Speed Calling - Station [S-21]
(3) All features which use the additional digits information by AACD command.
(4) Last Number Called - D [L-6D]
• A pause which is inserted per one pause is about three seconds.
• The plural pauses can be inserted. For the number of the digit which can be inserted, see each feature
conditions.
This feature is available when (1), (2), or (3) is stored in a Desktop Terminal.
Note 2:
<Conditions Specific to UMG System>
Each LMG accommodates Internal PHI-BRI in UMG system. Therefore, Internal PHI-BRI must be acti-
vated in all the LMG that accommodates Virtual Trunk of MG (COT) when using MG (COT).

Interaction with other features

1. When using Location Diversity
MG (COT) data need to be assigned to all channels although physical connection with lines is not neces-
sary.
Note 2
VOL.2-221
MC & MG with PFT