NEC Univerge sv8500 Manual page 1246

Δ
6. SHOW E_T_TIME
This command is used to display an executing time of EC Training feature.
MG-PRI > SHOW E_T_TIME
EC Training Feature time is 32.
7. SHOW Δ E_T_WAITTIME
This command is used to display the waiting time (ms) before starting EC training feature. 1 counter indi-
cates 10ms.
MG-PRI > SHOW E_T_WAITTIME
Counter value of EC Training start wait time
is 10.
8. SHOW Δ EC_TRAINING
This command is used to display the training feature of Echo Canceller (EC). Echo Canceller Feature is
used to prevent initial Echo (ranging from 500 to 1ms) from occurring in the beginning of speech to PBX
MG-PRI> SHOW EC_TRAINING
EC Training Feature is ON.
9. SHOW Δ FAXERRORDETECT
This command is used to display an available time to be switched to FAX.
MG-PRI > SHOW FAXERRORDETECT
Change effective time of FAX is 1 minute.
10. SHOW Δ INTERFACE
This command is used to display the connection mode of LAN interface.
MG-PRI > SHOW INTERFACE
Ethernet SPEED : 100Mbps, DUPLEX : HALF
axDev0 is needed as P1 when the program version is SW-423 PRI MG PROGRAM-A or earlier.
Note:
The current setting is displayed.
The current setting is displayed.
The current setting is displayed.
The current setting is displayed.
The current setting is displayed.
VOL.2-993
MG-PRI/PRA