Δ
2.
SETUP
TP
This command is used to set up network environment of MG(PRI) Proprietary Protocol Mode.
MG-PRI(SIP)>SETUP TP
---DHCP Interface set---
Current DHCP Interface:ENABLE
Change DHCP Interface? [Y (change)/N (current)/Q
(quit)]: Y
Input new DHCP Interface [E (enable)/D (disable)]:D
--- IP Address & Subnetmask set ---
Current IP Address: 0.0.0.0
Current Subnetmask: 255.255.255.255
Change IP Address and Subnetmask? [Y (change)/N (cur-
rent)/Q(quit)]: Y
Input new IP Address: 10.41.1.100
Input new Subnet mask: 255.255.255.0
--- Default Gateway IP Address set ---
Current Default Gateway: 0.0.0.0
Change Default Gateway? [Y (change)/N (current)/
Q(quit)]: Y
Input new Default Gateway: 10.41.1.254
--- DRS IP Address set ---
Current DRS Server/IP Address/Port Number:
Primary
DRS Address
Secondary
DRS Address
Tertiary
DRS Address
Fourth
DRS Address
0.0.0.0
, Port 3456
0.0.0.0
, Port 3456
0.0.0.0
, Port 3456
0.0.0.0
, Port 3456
VOL.2-1089
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]
The current setting is displayed.
1) Select the DHCP setting.
Y: Change the setting
N: Remain the current setting
Q: Exit the command
2) Enable/Disable the DHCP Server.
E: Enable a new DHCP Server
(default)
D: Disable DHCP Server
The current setting is displayed.
3) Select the network setting of
MG(PRI).
Y: Change the setting
N: Remain the current setting
Q: Exit the command
4) Specify the IP address of
MG(PRI).
5) Specify the subnet mask of
MG(PRI).
The current setting is displayed.
6) Select the default gateway set-
ting.
Y: Change the setting
N: Remain the current setting
Q: Exit the command
7) Specify the IP address of the
default gateway. Note that default
gateway should be located in the
same segment with MG(PRI).
The current setting is displayed.