NEC Univerge sv8500 Manual page 805

Type "setup" here for a firmware version of earlier than SP-3875 6MG COT PROG-A Ver.3.0.0.0.
Note 1:
If the firmware version is earlier than SP-3875 6MG COT PROG-A Ver.2.0.0.0, whether to use DHCP op-
Note 2:
tion will be asked after DHCP server is set for use ("y" is input) here. The procedures in this case are as
follow, depending on the answer.
• When DHCP Option is used
Use DHCP?
Input [Y(Yes)/N(No)/Q(Quit)]:y
Use DHCP option? (Get DRS address)
Input [Y(Yes)/N(No)/Q(Quit)]:y
--------------------------------------
MG-ID = xx:xx:xx:xx:xx:xx
DHCP = ENABLE
--------------------------------------
Input [Y(Yes)/N(No)/Q(Quit)]:y
• When DHCP Option is NOT used
Use DHCP?
Input [Y(Yes)/N(No)/Q(Quit)]:y
Use DHCP option? (Get DRS address)
Input [Y(Yes)/N(No)/Q(Quit)]:n
DRS1 ADDRESS (XXX.XXX.XXX.XXX):1.1.1.1
--------------------------------------
MG-ID = xx:xx:xx:xx:xx:xx
DHCP = ENABLE
DRS1 ADDRESS = 1.1.1.1
--------------------------------------
Input [Y(Yes)/N(No)/Q(Quit)]:y
About IP address of DRS (Telephony Server), refer to "Registration Destination of IP Devices/Stations" in
Note 1:
INTRODUCTION of Installation Manual.
MG-COT Card [SCA-6COTA/SCA-6COTC]
Set whether to use DHCP option. This option is the
function to get DRS address from DHCP server.
Input "y" here and press Enter key.
Set whether to use DHCP option. This option is the
function to get DRS address from DHCP server.
Input "n" here and press Enter key.
Assign the IP address of DRS. Note 1
VOL.2-552