NEC Univerge sv8500 Manual page 1377

Δ Δ
31. SHOW VLAN [P1]
This command is used to display the VLAN.
When P1 is not entered:
MG-PRI(SIP)>SHOW VLAN
DEVICE ID COS
VLAN1 1 0
When P1=1:
MG-PRI(SIP)>SHOW VLAN
DEVICE ID COS
VLAN1 1 0
Δ
32. SHOW WARNING_TONE
This command is used to display the warning tone setting.
MG-PRI(SIP)>SHOW WARNING_TONE
Warning Tone Control of IP Network is 3 (IP&ISDN side).
14.4.9 PING Command
1. PING Δ P1
This command is used to check the connectivity of network.
MG-PRI(SIP)>PING 10.41.1.100
PING 10.41.1.100: icmp_seq=0. time=0. ms
PING 10.41.1.100: icmp_seq=1. time=0. ms
PING 10.41.1.100: icmp_seq=2. time=0. ms
PING 10.41.1.100: icmp_seq=3. time=0. ms
----10.41.1.100 PING Statistics----
4 packets transmitted, 4 packets received, 0% packet loss
round-trip (ms) min/avg/max = 0/0/0
IPADDRESS SUBNETMASK
10.123.123.123 255.255.255.0
IPADDRESS SUBNETMASK
10.123.123.123 255.255.255.0
VOL.2-1124
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]
The current setting is displayed.
P1- Specify VLAN ID.
If omitted, all the VLAN are displayed.
P1-Specify IP address
Result is displayed.