NEC Univerge sv8500 Manual page 1140

VLAN Information set
Assign the VLAN data.
--- VLAN Information set ---
Current VLAN Information:
Device VLAN 1
Change VLAN Information? [Y (change)/N (current)/
Q(quit)]: y
Input new VLAN ID (0-4094): 1
Input new COS (0-7): 6
Input new IP Address: 10.41.1.200
Input new Subnet mask: 255.255.255.0
Do not assign the following addresses (network address, broadcast address) to MG(BRI).
Note:
(example)
- IP address 192.168.1.0/Subnet mask 255.255.255.0 (192.168.1.0 is network address, improper)
- IP address 176.16.0.0/Subnet mask 255.255.0.0 (176.16.0.0 is network address, improper)
- IP address 192.168.1.255/Subnet mask 255.255.255.0 (192.168.1.255 is broadcast address, improper)
- IP address 176.16.255.255/Subnet mask 255.255.0.0 (176.16.255.255 is broadcast address, improper)
As IP address of MG(BRI), Default Gateway, and the Telephony Server is get by DHCP server, there is no
need to assign these network data on MG(BRI) side. IP addresses listed below, however, need to be as-
signed on DHCP server side.
• IP address of Default Gateway
• IP address of the Telephony Server
Check the number of IP address saved in DHCP server is sufficient so as to get IP address of MG(BRI)
Note 1:
anytime.
DHCP option setting is as follows.
Note 2:
Class: Global
Name: Not specified, but do not enter the same option name in duplicate
Data: IP address
Array: Checked
Code: 162
ID COS IP Address
1 7 10.41.1.200
Note 1
Note 2
Current data setting is displayed.
Subnetmask
255.255.255.0
Asked whether to change the displayed data.
Y: To change the displayed data
N: Not change
Q: Quit Standard mode
VLAN ID: 0-4094
CoS setting: 0-7
Enter the IP address of VLAN.
Enter the subnet mask of VLAN.
VOL.2-887
MG(BRI) [SCA-2BRIA/MG-2BRIA]