NEC Univerge sv8500 Manual page 585

AISTL: Assignment of IP Station Data (LDM)
Assign the IP Station Data of each terminal connected to the MC by the AISTL command.
TN: Tenant Number [1-63]
IP STN: Station Number of IP Station (assign the station number for each analog terminal connected to
the MCMG)
KIND: Kind of IP Terminal. Select the terminal kind MC-MG (COT) in the combo box
TEC: Telephone Equipment Class [2, 3, 14]
RSC: Route Restriction Class [0-15]
SFC: Service Feature Restriction Class [0-15]
LENS: IP Station Equipment Number as Virtual LENS. Allocate the IP station to the Virtual LENS
within Virtual PIR, or to the LENS of a vacant slot that the Station/Trunk is not mounted (an IP
station cannot be assigned to a registered station multiple times.)
For a detailed explanation of data assignment for a Virtual PIR, see the Data Programming Manual.
Note:
MC-ID: ID of the MCMG (enter the fixed MAC Address of the MCMG)
MC-CH: Channel Number of the MC (assign 0-3 (Port 0-3)) for each analog terminal connected to the
MCMG)
FAX Data Setting:Click the check box to ON when manual data setting is required for Fax communication.
JITSIZ:
PAYTYP x:Select the Payload Type G.711/G.726/T.30 in the combo box.
PAYSIZ x: Select the Payload Size 10ms-40ms (required for G.711 and G.726).
ALOCL: Assignment of Location ID Data (LDM)
Each IP terminal is allocated a Location ID to identify its location within the network on Network Address
basis. By using the Location ID, IP services such as Bandwidth Control and ToS Control are provided for
each IP terminal.
TYPE: Select "Network Address".
IP ADDRESS: Enter the IP Address. For the Telephony Server (IPPAD), assign "0.0.0.0".
MASK BIT: Enter the Mask Bit in the range of 1-31 except when IP Address 0.0.0.0 is determined. Mask
Bit=32 is automatically set when IP Address=0.0.0.0
NETWORK ADDRESS: Display only.
LOC-ID: Assign the Location ID in the range of 0-4095, associated with the IP Address. When IP Ad-
dress=0.0.0.0, LOC-ID=0 is automatically set (the value cannot be changed).
LOC-ID=0 is predetermined to the Location ID of the Telephony Server (i.e. IPPAD).
Note:
Setting Type of Signaling Packet Service: Click the check box to assign the ToS for signaling packet.
IP PRECEDENCE/DIFFSERV:
<When IP PRECEDENCE is selected>
Priority:
Low Delay:
Through Put:
Reliability:
MIN Cost:
<When DIFFSERV is selected>
Priority:
Enter the Jitter Buffer size in the range 1-30 (
Specify the precedence in the range of 0-7 (low-high).
Place a checkmark to set Low Delay to ON.
Place a checkmark to set High Throughput to ON.
Place a checkmark to set High Reliability to ON.
Place a checkmark to set Cost Precedence to ON.
Specify the DiffServ Code Point in the range of 0-63.
VOL.2-332
MCMG [SCA-4LC2COTA/MG-4LC2COTA]
10ms) for Fax controlling.
×