14.3.2 Terminal Software Setting on Maintenance Console
STEP 1: Connect a PC (maintenance console) to CONSOLE connector.
STEP 2: Run terminal software (e.g. HyperTerminal) on the Maintenance Console.
STEP 3: Set the parameter of the terminal software as follows:
•
Port: COM1 (depending on PC setting)
•
Baud Rate: 9600 bps
•
Data: 8 bits
•
Parity: None
•
Stop Bit: 1
•
Flow Control: None
For the detailed procedure of Terminal Software (HyperTerminal) setting, refer to Vol.1, Chapter 2, "2. IP
Note:
Related Basic Programming" in this manual.
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]
VOL.2-1045
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required