NEC Univerge sv8500 Manual page 1145

12. SET SIGNALING_PORT_NO
Assign the port number to be used for PHI signaling.
MG-BRI>set signaling_port_no
Port Number (1024-65535): 64000
Default configuration is '64000',
if you will not change a configuration by using this command.
In order to make a setup reflect and keep, re-starting is
required after saving a configuration data by SAVE command.
PHI is the internal controlling function in SIP server, that is, SP-PHI in the Telephony Server. Specify the
Note:
same port number assigned on SIP server.
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
13. SET SIGNALING_QOS
Assign the ToS value added to signaling (SIP server signaling) session.
MG-BRI>set signaling_qos
QOS [I(IP PRECEDENC)/D(DIFFSERV): IP PRECEDENCE]: P1
• When P1=IP PRECEDENCE is specified:
QOS[I(IP PRECEDENCE)/D(DIFFSERV):I]:I
PRECEDENCE(0-7:6):6
DELAY(0/1:0):0
THROUGHPUT(0/1:0):0
RELIABILITY(0/1:0):0
COST(0/1:0):0
Default Configuration is 'IP PRECEDENCE[0xC0]',
if you will not change a configuration by using this command.
In order to make a setup reflect and keep, re-starting is
required after saving a configuration data by SAVE command.
P1: I/D
I: IP Precedence type data assignment
D: DIFFSERV type data assignment
VOL.2-892
MG(BRI) [SCA-2BRIA/MG-2BRIA]
Port number (1024-65535)
(default: 64000)
I: When (IP PRECEDENCE) is selected
Precedence in IP network (0-7)
(6: Default)
Precedence of Low Delay in IP network
0: Not specified (Default)
1: Specified
Precedence of Throughput in IP network
0: Not specified (Default)
1: Specified
Precedence of Reliability in IP network
0: Not specified (Default)
1: Specified
Precedence of Lower Cost in IP network
0: Not specified (Default)
1: Specified