NEC Univerge sv8500 Manual page 1375

Δ
26. SHOW SMOOTH_PAD
This command is used to display Smooth PAD mode of DSP.
MG-PRI(SIP)>SHOW SMOOTH_PAD
Smooth PAD Mode is 2.
27. SHOW Δ STARTPORT
This command is used to display the start port of RTP.
MG-PRI(SIP)>SHOW STARTPORT
RTP Start Port Number is 1024.
28. SHOW Δ STATUS
This command is used to display the status of MG(PRI).
MG-PRI(SIP)>SHOW STATUS
Register Mode
MAC Address
Link State
Speed
Duplex
VLAN Mode
DHCP Mode
IP Address
Subnet Mask
Default Gateway
DNS Mode
DNS Server Address
Encryption
+--SIP Encrypt
+--RTP Encrypt
Current Sipsv
Address
Registration Status
+--Registration is Started now
29. SHOW Δ TCP_TIMER
This command is used to display the setting of the timer for TCP Link Connection
MG-PRI(SIP)>SHOW TCP_TIMER
TCP Link Connect Timer Timeout is 60 seconds.
: SP
: 00:00:4c:a4:00:01
: Up
: 100Mbps
: Full
: Enable
: Disable
: 10.10.10.98
: 255.255.255.0
: 10.10.10.254
: Enable
: 10.10.10.150
:
: --
: Enable
: 0.0.0.0
: Offline
VOL.2-1122
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]
The current setting is displayed.
The current setting is displayed.
The current setting is displayed.
The current setting is displayed.