NEC Univerge sv8500 Manual page 578

7.3.1 Data Assignment by PCPro
This section explains the data assignment procedures to the Telephony Server by PCPro.
This equipment needs to be considered beforehand either Internal PHI-BRI or SP-PHI is set as the regis-
Note:
tration destination. Please make sure details of "Consideration for SP-PHI Data Assignment" in Chapter
2 of Data Programming Manual - Business before data assignment.
For UG50, refer to " UG50 Installation Guide".
Note:
<When registering to Internal PHI-BRI>
MG part of MCMG can be registered to either Internal PHI-BRI or SP-PHI. Here explains MCMG data assign-
ment for registering to Internal PHI-BRI. When registering to SP-PHI, refer to
[1] Internal PHI-BRI Data Assignment
When MG part of MCMG is registered to Internal PHI-BRI embedded in the Telephony Server, Internal PHI-
BRI data assignment is necessary. About the procedure for the Internal PHI-BRI data assignment, refer to Vol.1,
Chapter 2, "2. IP Related Basic Programming" in this manual. The explanation of PHs including Internal PHI-
BRI is also there.
[2] MG Data Assignment
Assign the necessary System Data for using the MG.
ASYD: Assignment of System Data
SYS1
INDEX 186, b6=1 (ISDN/MG (COT) is in service)
INDEX 187=00 (Fixed)
INDEX 474 Guard Timer For Originating Call (MTC
bit 0-3 (MTC)
bit 4-6 (TC) Note: When assigning 1H, TC = 64 msec.
ARTD: Assignment of Route Class Data
Assign the Route Class Data for Virtual Speech Channel. The following data setting is necessary besides
Analog C.O BWT setting.
CDN1 OSGS = 0
CDN60 TC/EC = 1
CDN114 DCH = 1
CDN125 MGCOT = 1
When digits conversion is required for the received digits, assign the following data.
CDN66 (DC): Dialed Number Confirmation
Assign the number of digits for identifying the incoming line. Count the digits from the last one of the re-
Note:
ceived number.
CCIS
Echo Canceler is available
Unify the channel
MG (COT) is available
VOL.2-325
MCMG [SCA-4LC2COTA/MG-4LC2COTA]
page
×
TC)
335.