NEC Univerge sv8500 Manual page 816

STEP 2: Connect C.O. Lines to MG0-MG5.
FRONT
100M LINK 100M LINK
PWR ALM
Ether
to C.O. line
STEP 3: Check the lamp indication on the front panel of MG-COT Card.
- PWR lamp: lights green
- ALARM lamp: OFF
- ON LINE lamp: OFF
- OPERATION MG0~MG5: flashes green
After the data assignment (MG-COT Card entry, incoming/originating outside call data) on the Telephony
Note:
Server side has been completed, ON LINE lamp lights green and the corresponding OPERATION MG
lamps will go out.
Connecting C.O. Lines
MG0 MG2 MG4 PFT
MG1 MG3 MG5
MG0 MG2 MG4
ON
LINE
MG1 MG3 MG5
OPERATION
VOL.2-563
MG-COT Card [SCA-6COTA/SCA-6COTC]
MG0-MG5 connector
CONSOLE
MUSIC
RESET
MG6
RJ-11connector
pin assignment
2 1
B A