NEC Univerge sv8500 Manual page 865

INIT (CLEAR) COMMAND
To initialize the configuration data to factory default value
MG-COT > INIT CONFIGDATA
*** Warning !! ***
This command is for initialize config data.
If this command is executed, your configuration
is deleted!!
OK ? (Y/N) : y
It's recommended to back up your configuration !!
really OK ? (Y/N) : y
Initialize of configuration data was successful.
You need to setup config data!!
MG-COT >
The designated operating status cannot refer when SP-3875 6MG COT PROG-A Ver.3.0.0.0 or later.
Note:
• SP-3875 6MG COT PROG-A Ver 3.0.0.0 or earlier
MG-COT> CLEAR CONFIG
[SYSTEM]
LONG_TIMEOUT=30
SHORT_TIMEOUT=5
:
:
Configuration data initial setting succeeded.
Reboot.....
MG-COT Card [SCA-6COTA/SCA-6COTC]
VOL.2-612