NEC Univerge sv8500 Manual page 1230

The result of data setting is indicated in 1-byte (Hex.) format in accordance with the setting dialog followed
Note:
by prompt. The meaning of 1-bite data is as shown below:
When selecting TOS (IP Precedence Type)
7 6 5 4
Prec D
When selecting Diffserv
6 4 3 2
7 5
DSCP= Diffserv Codepoint (6 bits)
17. SET Δ SMOOTH_PAD
This command is used to specify Smooth PAD mode of DSP. To make this assignment effective, it is re-
quired to execute the "SAVE" command and to restart before exiting the maintenance command.
MG-PRI > SET SMOOTH_PAD 2
Smooth PAD Mode setting succeeded.
In order to make a setup reflect, re-starting is
required after saving a configuration file by
SAVE command.
Δ
18. SET STARTPORT
This command is used to specify the starting port of RTP. Enter an even number for the RTP. The odd num-
ber (the even number +1) is assigned for RTCP. To make this assignment effective, it is required to execute
the "SAVE" command and to restart before exiting the maintenance command.
MG-PRI > SET STARTPORT 1024
Number of RTP start port setting succeeded.
In order to make a setup reflect, re-starting is
required after saving a configuration file by
SAVE command.
3
2 1 0
T
R C
1 0
Δ P1
Δ
P1
VOL.2-977
111
High
110
101
100
Priority
011
010
001
Low
000
High EF
EF (Expedited Forwarding): 101110
AF (Assured Forwarding):
AF
BF (Best Effort):
Low
BF
P1-Specify a value of Smooth PAD mode.
1-5=Mode Number of Smooth PAD (Default: 3)
OFF=Set Smooth PAD mode to OFF
A command is executed, and the result is displayed.
P1-Specify the port number to start RTP
1024-64510= Port Number (Default: 1024)
A command is executed, and the result is displayed.
MG-PRI/PRA
Prec.=PRECEDENCE (3 bits)
D=Delay
T=Throughput
R=Reliability
C=Cost
111110
000010
000000