NEC Univerge sv8500 Manual page 628

SET COMMAND (MG side)
1. Setting Call Hold
MC-MG> SET CALL_HOLD DISABLE
CALL HOLD setting succeeded.
By setting "ENABLE" by this command, if a network failure occurred between the Telephony Server and
Note:
MCMG, the call will be retained. The system will be rebooted automatically and re-registered to the Tele-
phony Server after the call of all channels in MCMG are released.
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
2. Setting CAR Detection
MC-MG> SET CAR_DETECT OFF
CAR Detecting setting succeeded.
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
3. Setting CODEC Coefficiency:
MC-MG > SET CODEC_COEF_MG 1 2
CODEC Coefficient (CH01) setting succeeded.
The setting values are shown in the following table. Setting value "2" is assigned when the product is
Note:
shipped. Change the data if required.
• North America
RESISTER
600Ω+2.16μF
600Ω+2.16μF
MCMG [SCA-4LC2COTA/MG-4LC2COTA]
Line 1: Select the Call Hold setting
DISABLE=Call Hold Mode is invalid. (default)
ENABLE=Call Hold Mode is valid.
Line 2: Result is shown
Line 1: Select the Number Detection
OFF=Invalid (default)
ON=Valid
Line 2: Result is shown
Line 1: Enter the Line Number 0-3. And then, enter
the setting value (default=2) after the space.
Line 2: Result is shown
KIND OF BNW
600Ω+2.16μF
600Ω
VOL.2-375
SETTING VALUE
0 (default)
1