NEC Univerge sv8500 Manual page 992

ARTD: Assignment of Route Class Data
Assign the Route Class Data of Virtual Speech Channel.
CDN65(INT): Interface Specification for ISDN.
Refer to ARTD section in the Command Manual for your country's specification.
Note:
CDN60 (TC/EC)=1 (TC)
CDN114 (DCH)=1 (Channel Integration Enabled)
To change the data for existing route (RT), initialize or reboot the trunk device such as circuit card, MG, or
Note:
VS-32.
ARTI: Assignment of Trunk Application Data
Assign the application data for Trunk in Virtual Speech Channel.
CDN68 (VIR)=2 (MG connection)
To change the data for existing route (RT), initialize or reboot the trunk device such as circuit card, MG, or
Note:
VS-32.
ATRK: Assignment of Trunk Data
Assign the Trunk Data to Virtual Speech Channel.
The example of data setting procedure is shown below.
Virtual trunk occupies one group. For example, if one channel is registered for Virtual Trunk, the group is
Note:
occupied exclusively for the Virtual Trunk.
Do not assign any trunk data to Group 0 of Unit 0 in even number Module Group because it cannot be used
Note:
with MG-BRI.
VOL.2-739
MG-BRI