NEC Univerge sv8500 Manual page 948

6. Setting ToS of DRS session
MG-COT > SET DRSTOS PRECEDENCE
PRECEDENCE (0-7) : 6
DELAY (0/1) : 0
THROUGHPUT (0/1) : 0
RELIABILITY (0/1) : 0
COST (0/1) : 0
DRS TOS setting succeeded.(0xC0)
The result of data setting is shown in a 1-byte (hexadecimal) format in accordance with the setting dialog
Note:
followed by the prompt. The meaning of 1-byte data is shown below:
Prec.
MG-COT > SET DRSATOS VALUE
TOS (00-FF) : C0
DRS TOS setting succeeded.(0xC0)
The designated DRS ToS cannot be applied when SP mode. Assign the Proprietary Protocol mode before
Note:
executing this DRS ToS setting.
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
D T R C
Line 1: Enter sub command name
Line 2: Precedence:0-7(low-
Line 3: Delay:0/1=Nomal(default)/Low
Line 4: Throughput:0/
Line 5: Reliability:0/1=Nomal(default)/
Line 6: Cost:0/1=Nomal(default)/Cost
Line 7: Result is shown.
Prec.=PRECEDENCE (3 bits)
D=Delay
T=Throughput
R=Reliability
C=Cost
Line 1: Enter the sub command name
Line 2: Specify the value in the range of
Line 3: Result is shown.
VOL.2-695
MG-COT Card [SCA-6COTB]
PRECEDENCE to set the
parameters such as Delay,
Throughput, Reliability, and
Cost. Specify the value to each
parameter.
high)(default=6)
Delay ON
1=Nomal(default)/High
Throughput ON
High Reliability ON
Precedence ON
VALUE to set the DRS setting
value Directly.
00-FF(default=C0).