NEC Univerge sv8500 Manual page 1002

• When DHCP Server is Disabled
Setting on MG-BRI side is necessary. IP Addresses of the following listed items need to be assigned on
MG-BRI.
Note 1
• Default Gateway
• DRS
Note 2
• MG-BRI
IP Addresses assigned here are not effective when DHCP Server has been "Enabled". Confirm to set
Note 1:
DHCP Server to "Disabled" before setting these IP Address.
About IP address of DRS (Telephony Server), refer to "Registration Destination of IP Devices/Stations" in
Note 2:
INTRODUCTION of Installation Manual.
• Assign the IP Address of the Default Gateway. (IP Address below is an example)
MG-BRI>set default_gateway 192.168.100.254
• Assign the IP Address and Port number of the DRS (Telephony Server). (Value below is an example)
MG-BRI>set drs_ipaddress
Please enter DRS Unit(1:Primary/2:Secondary/
3:Tertiary/4:Forth):1
IP Address: 192.168.100.1
Port Number: 3456
• Assign the IP Address and Subnet Mask of the MG-BRI
MG-BRI>set own_ipaddress
OWN IP address: 192.168.100.10
Subnet mask: 255.255.255.0
• Save the configuration data assigned.
MG-BRI>save config
** Don't power off in progress **
Do you need save? [Y/N]:Y
• Reboot the MG-BRI (
MG-BRI>reboot
)
Note 1
VOL.2-749
Assign the IP Address
DRS Unit: Assign "1" (Primary)
Assign the IP Address
Enter the Port number (e.g. 3456).
(Value below is an example)
.
Assign the IP Address
Assign the Subnet Mask
Enter "Y" and save the configuration data.
MG-BRI