NEC Univerge sv8500 Manual page 903

•
It is not necessary to assign the payload type/size to the whole priorities. Specifying the first priority
only is allowed.
• For available payload type/payload size, refer to Peripheral Equipment Description, Volume 1, Chapter
2, "3.1.1 Bandwidth Required for Voice Traffic."
Setting of PAD: Click the check box to assign the PAD data manually. If not checked, default value 0 is
KIND2: Specify the PAD value of Analog MC in the range of 0-3.
KIND3: Specify the PAD No. of IPPAD in the range of 0-15.
Setting of Echo Canceller: Click the check box to assign the Echo Canceller data, and select one of the ra-
When the same value is assigned to both "A LOC-ID" and "B LOC-ID" parameters, select either "A EC-
Note:
ON/B EC-ON" or "A EC-OFF/B EC-OFF".
MG-COT needs to be rebooted after station data is assigned to reflect change. Confirm that there is no con-
Note:
versation in progress when rebooting.
[*] Data Deletion
Deletion must be operated in the reverse order of assignment. Make sure to delete in the order of AMGIL
ATRK. (Confirm there is no data left in AMGIL before deleting ATRK)
Operate the ASYD/ASYDL/ALIDL deletion carefully because these commands are also used by other euip-
ments.
applied.
•No PAD control (determined by ASYD, SYS1, INDEX 4, bit5 (5 dB PAD))
•PAD OFF (0 dB)
•3 dB
•6 dB
PAD value is determined by this PAD No. (0-15) and the setting of SW10-6/7 on IPPAD
card. Refer to the Circuit Card Description for more details.
dio buttons.
•A EC-ON/B EC-ON
•A EC-ON/B EC-OFF
•A EC-OFF/B EC-ON
•A EC-OFF/B EC-OFF
VOL.2-650
MG-COT Card [SCA-6COTB]
→