NEC Univerge sv8500 Manual page 1346

Δ
5. SET DNS_SW
This command is used to enable/disable DNS server. A bracket ([ ]) shows the current setting. To make this
assignment effective, it is required to execute the "SAVE" command and to restart before exiting the main-
tenance command.
MG-PRI(SIP)> SET DNS_SW
DNS interface (Enable/Disable)
[DISABLE] : ENABLE
DNS IP Address [0.0.0.0] :
10.41.1.150
DNS setting succeeded.
6. SET Δ DRSADDRESS
This command is used to specify IP address for DRS.To make this assignment effective, it is required to
execute the "SAVE" command and to restart before exiting the maintenance command.
MG-PRI(SIP)>SET DRSADDRESS
DRS Unit (1:Primary/2:Secondary/3:Tertiary/4:Fourth):1
DRS IP Address: 150.12.0.254
DRS Port Number: 3456
DRS setting succeeded.
About IP address of DRS (Telephony Server), refer to "Registration Destination of IP Devices/Stations" in
Note 1:
INTRODUCTION of Installation Manual.
7. SET Δ DRSQOS
This command is used to specify Quality of Service (QOS) such as IP Precedence and Differentiated Ser-
vice (DIFFSERV) for DRS. To make this assignment effective, it is required to execute the "SAVE" com-
mand and to restart before exiting the maintenance command.
MG-PRI(SIP)>SET DRSQOS TOS 0xC0
When P1 is not entered:
MG-PRI(SIP)>SET DRSQOS
QOS (TOS/DIFFSERV:TOS):TOS
Δ [P1] Δ [P2]
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]
P1- Enter the following after the command name
ENABLE=DNS is valid (default)
DISABLE=DNS is invalid
Result is displayed.
P1-Specify a type of services
TOS: IP Precedence
DIFFSERV: Differentiated Service
CLEAR: Clear the data
P2-Specify a value
00-FF (In the case of TOS)
0-63 (In the case of DIFFSERV)
1) Specify TOS for QOS
VOL.2-1093
1) Select the applying type for DRS
1=Primary
2=Secondary
3=Tertiary
4=Fourth
2) Specify IP address Note 1
3) Specify port number of DRS
(default: 3456)
Result is displayed.