NEC Univerge sv8500 Manual page 511

6.4 Operation and Maintenance
6.4.1 How to Use Maintenance Command
"DRS (Device Registration Server)" used in this section refers to Telephony Server. Telephony Server acts
Note:
as DRS for MC & MG with PFT using Proprietary Protocol.
When MC & MG with PFT reboots itself due to such as an occurrence of health check timeout while main-
Note:
tenance commands are executed, it takes about five minutes to start rebooting.
On a serial connection client (ex. HyperTerminal), start up the program and use maintenance command. Enter
"usrConsole" after the OS prompt (->).
When the maintenance command is started, the following prompt is indicated on the screen:
MC-MG>_
An example of indication is shown below:
MC-ID: 00004ca41cfd
Boot program version: SP3777 MCMG BOOT PROG-A [05.00.00.00]
Main program version: SP3778 MCMG PROG-A [10.00.00.00]
DSP kernel version:
DSP program version:
DSP kernel version:
DSP program version:
MUSIC information:
H/W information:
H/W information:
Starting MC-MG Boot program.......
--- Online program Initial start --- (wait 30sec)
Attached TCP/IP interface to axDev unit 0
Attaching interface lo0... done.
Adding 7914 symbols for standalone.
------//----------------------------------------//---
Media Converter - Media Gateway (COT Interface)
---//----------------------------------------//------
->
->
->
->
-> usrConsole
MC-MG Maintenance command Version 1.00
MC-MG >
("machine name" + ">", usually)
DSP-K-AC48104ak[03.10.00.00]
DSP-P-AC48104ae3[03.10.00.00]
DSP-K-AC48302ck[03.10.00.00]
DSP-P-AC48302ce6[03.10.00.00]
SM0901 0900 0000 0000
TEST-PKG-MC
TEST-PKG-MG
*Firmware SP-3778
*Compiled on Aug 22 2003 11:46:56
VOL.2-258
( 10.00.00.00 )
2001.07.19
MC & MG with PFT