NEC Univerge sv8500 Manual page 1069

MBTK (Make Busy of Trunk)
Cancel the Make-Busy of Virtual Speech Path.
RT: Route Number
TK: Trunk Number
MB: 0=Make-Busy Cancel
AMGIL (Assignment of Media Gateway Information for LDM)
Make sure to assign in order of ATRK
Note:
Assign MG(BRI).
MG-ID: MAC Address of MG(BRI) (6 byte of HEX data)
* MAC address is labeled on the left front of MG(BRI) (below PWR lamp).
FUNCTION:Setting (to assign MG information)
KIND: ISDN Trunk (BRI)[SIP]
LINE: 0/1 (MG Line Number)
CH: 0/1 (Channel B1/Channel B2)
LENS: Accommodating Location of Virtual Speech Channel
* Make sure that LENS number assigned here already has been assigned by the ATRK.
SETTING OF SERVICE TYPE EXISTS (Signaling Packet):
Place the check box ON to assign ToS data for signaling control of MG(BRI).
IP Precedence [0-7]/Diffserv [00-63]
MUSIC ON HOLD EXISTS:Place the check box ON to select hold-tone type.
External Music-on-Hold
Internal Music-on-Hold 1
Internal Music-on-Hold 2
The gain value decreases when the PAD is assigned at - (minus) value, to turn up the level of external mu-
Note:
sic-on-hold.
EMERGENCY TELEPHONE: Automatic cancel/Manual cancel
FUNCTION:RESET
ACTION AFTER RESET: Startup with operation mode/Startup with emergency telephone mode
Both channels CH0 and CH1 need to be assigned together. Do not assign individually. (Same condition is
Note:
applied when deleting the data)
AMGVL (Assignment of Media Gateway Voice Control Data for LDM)
Assign the Voice control data to connect to MG(BRI).
*AIVCL command setting turns effective if AMGVL is not assigned.
A RT (Storing MG):Route number of virtual speech channel used for MG(BRI).
→ AMGIL.
Select Input gain adjustment.
0=0dB (default)
1=-10dB (gain)
2=-15dB (gain)
3=-20dB (gain)
VOL.2-816
MG(BRI) [SCA-2BRIA/MG-2BRIA]