NEC Univerge sv8500 Manual page 1247

Δ
11. SHOW IPADDRESS
This command is used to display the IP address of LAN interface.
MG-PRI > SHOW IPADDRESS
IP Address 222.1.2.3
Netmask 255.255.255.0
Default Gateway 222.1.12.254
axDev0 is needed as P1 when the program version is SW-423 PRI MG PROGRAM-A or earlier.
Note:
12. SHOW Δ MEDIAQOS
This command is used to display the QOS setting for RTP session. The following is an example in the case
of TOS (IP Precedence) setting.
MG-PRI > SHOW MEDIAQOS
RTP QoS is 0xC0. (QOS:TOS)
PRECEDENCE=6
DELAY=0
THROUGHPUT=0
RELIABILITY=0
COST=0
13. SHOW Δ SIGQOS
This command is used to display the QOS for signaling session. The following is an example in the case
of DIFFSERV setting.
MG-PRI > SHOW SIGQOS
Signaling QoS is 0xC0. (QOS:DIFFSERV)
DSCP=48
The current setting is displayed.
-Precedence (0-7 (low-high))
-Delay (0/1=Normal/Delay is ON)
-Throughput (0/1=Normal/High Throughput ON)
-Reliability (0/1=Normal/High Reliability ON
-Cost (0/1=Normal/Cost Precedence ON)
-Change effective timer
0=invalid to change to FAX mode
1-5=possible to change to FAX mode within 1-5
-Diffserv Codepoint (0-63)
The current setting is displayed.
VOL.2-994
MG-PRI/PRA