VLAN
VLAN feature applies to MC&MG as well as other IP terminals, such as a DtermIP. When dividing one
physical network into multiple networks virtually, priority control (giving precedence to Voice Packet) can
be activated.
Network data programming by the PCPro command ALIDL, and also setting VLAN to each MC&MG by
the maintenance command is required (see
an example network configuration when an MC&MG is used in VLAN.
For detailed explanation of the VLAN feature, refer to Data Programming Manual.
Note:
VLAN Example
VLAN data can be set from the maintenance terminal
by using maintenance command.
MC&MG
VLAN for Voice
Voice Packet
Data Packet
[2] MG Data Assignment in page
SW
VLAN for Data
VLAN data can be set by
the PCPro command ALIDL
VOL.2-202
MC & MG with PFT
227). The figure below shows
Router