NEC Univerge sv8500 Manual page 835

The designated operating status cannot refer when SP-3875 6MG COT PROG-A Ver 3.0.0.0 or earlier.
Note:
MG-COT> setup
MG-ID = 00:30:13:16:ae:fa
Use DHCP?
Input [Y(Yes)/N(No)/Q(Quit)]:y
Use DHCP option? (Get DRS address)
Input [Y(Yes)/N(No)/Q(Quit)]:y
--------------------------------------
MG-ID = 00:30:13:16:ae:fa
DHCP = ENABLE
--------------------------------------
Input [Y(OK)/N(Change)/Q(Quit)]:y
• When DHCP option is not used
MG-COT> setup
MG-ID = 00:30:13:16:ae:fa
Use DHCP?
Input [Y(Yes)/N(No)/Q(Quit)]:y
Use DHCP option? (Get DRS address)
Input [Y(Yes)/N(No)/Q(Quit)]:n
DRS1 ADDRESS (XXX.XXX.XXX.XXX):1.1.1.1
--------------------------------------
MG-ID = 00:30:13:16:ae:fa
DHCP = ENABLE
DRS1 ADDRESS = 1.1.1.1
--------------------------------------
Input [Y(OK)/N(Change)/Q(Quit)]:y
About IP address of DRS (Telephony Server), refer to "Registration Destination of IP Devices/Stations" in
Note 1:
INTRODUCTION of Installation Manual.
MAC address is displayed.
Enter "y".
Enter "y".
Setting result is displayed.
Enter "y" when the assigned data is correct.
:
MAC address is displayed.
Enter "y".
Enter "n".
Enter the IP address of DRS.
Setting result is displayed.
Enter "y" when the assigned data is correct.
VOL.2-582
MG-COT Card [SCA-6COTA/SCA-6COTC]
Note 1