NEC Univerge sv8500 Manual page 961

20. To show signaling port number for SIP
MG-COT(SIP) > SHOW SIGNALING_PORT_NO
Signaling Port Number is 5060
The designated Signaling Port Number cannot refer when Proprietary Protocol mode. Assign the SP mode
Note:
before executing this Signaling Port Number shown.
21. To show QoS setting for SIP signaling session
MG-COT(SIP) > SHOW SIGNALING_QOS
Signaling QoS is 0xC0. (QOS = TOS)
PRECEDENCE = 6
DELAY = 0
THROUGHPUT = 0
RELIABILITY = 0
COST = 0
The designated QoS cannot refer when Proprietary Protocol mode. Assign the SP mode before executing
Note:
this QoS shown.
22. To show IP address, port number, and host name of SIP server
MG-COT(SIP)> SHOW SIPSV_IPADDRESS
SIP Server IP Address
1 10.41.1.150
2 0.0.0.0
3 0.0.0.0
: :
: :
20 0.0.0.0
The designated SIP Server cannot refer when Proprietary Protocol mode. Assign the SP mode before exe-
Note:
cuting this SIP Server shown.
About IP address of SIP server (Telephony Server), refer to "Registration Destination of IP Devices/Sta-
Note:
tions" in INTRODUCTION of Installation Manual.
Port Number Host Name
5060 SVR1.nec.com
5060
5060
:
:
5060
VOL.2-708
MG-COT Card [SCA-6COTB]
The current setting is shown.
The current setting is shown. (*This
display is an example when TOS (IP
PRECEDENCE) type is selected.)
The current setting is shown.